AR15 Forums banner
1 - 8 of 8 Posts
G

·
Discussion Starter · #1 ·
I have heard of the Pmags not fitting into essential arms lowers. I was wanting to buy some but I dont want to get them if they wont fit. Has anyone had issues with this before ?
 
G

·
Discussion Starter · #2 ·
Where did you hear this ? What I heard was that Essential Arms lowers are spec.

Heard some S&W MP15's had issues ... one other ... nothing else.
 
G

·
Discussion Starter · #3 ·
I've "heard" that some of the essentail arms had bad milling. On the exterior, it just looks bad. On the magwell, it caused mag fitment problems.

Again, this is only from what I've read on AR15.com, not personally.

Hardwarz
 
G

·
Discussion Starter · #5 ·
I read it on AR15.com they said that the essential arms lowers were mil-spec but the pmags are out of spec and I guy had to trim his magwell to get them to work. They said most of the other companies make there lowers a little loser than milspec.
 
G

·
Discussion Starter · #8 ·
can some one give me magwell opening dimensions of a lower that works with pmags and can you also give me pmag dimensions.

Thanks,
Zac
 
1 - 8 of 8 Posts
Top