AR15 Forums banner

gas block roll pin frustrations...

2K views 6 replies 0 participants last post by  ichy_trigger 
G
#1 ·
so i bought the low profile gas block from PRI to go under my rail system, got everything off ok and when i go to put the gas tube in the gas block and put the roll pin back inside it won't fit! when i bought the pri gas block it didn't come with a roll pin so at first i was like "hmm ok, maybe it's all built to spec and the roll pin that i currently have will fix" is that a true statement or do they all vary?

any suggestions on how i can get this bugger in there?
:confused::mad:
 
G
#6 ·
Did you try sqeezing one end of the roll pin with pliers to get it started in the hole?

I bet you can find something suitable at a hardware store is someone could tell you what size roll pin that typically is.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top