AR15 Forums banner
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
Was wondering if anyone else had seen one of these marring the round if it is placed in the chamber and then extracted? Its on the round itself and it looks like a scratch. Seems to be firing fine - cycles perfectly while firing. If someone can post instructions on photos I'll throw up a picture of the round.
 
G

·
Discussion Starter · #2 ·
Pegasus3c said:
Was wondering if anyone else had seen one of these marring the round if it is placed in the chamber and then extracted? Its on the round itself and it looks like a scratch. Seems to be firing fine - cycles perfectly while firing. If someone can post instructions on photos I'll throw up a picture of the round.
may be getting scratched on the feed ramp. why are you doing this anyway? if the rifle is working fine and is accurate i don't think u have a problem.
 
G

·
Discussion Starter · #3 ·
I noticed it the other day when I was at the range when I cleared it to go down range. Now I have done it again... Wondering if it could be a sign of something badly wrong that I will have to fix later.
 
1 - 3 of 3 Posts
Top