AR15 Forums banner

1 - 9 of 9 Posts
G

·
Discussion Starter #1
I dont know if you can see it by the picture but my floor plate is coming off of a 10 round Bushy mag I got. It doesnt have the metal floor plate like my Stag does. Can I fix this or replace the FP with an aftermarket one? How do I get it all the way off?



 
G

·
Discussion Starter #3



stock photo
yours looks ok
they aren't made to be taken apart ;)
Its a small gap at the bottom opposite side of that little button. The last round doesnt chamber because its taken the tension out of the spring I think. I will try and take a better picture.
 
G

·
Discussion Starter #4
Can you tap it back in? I'd guess it is a friction type plug with that little locker nub about .5" up.
Slugger
 
G

·
Discussion Starter #6
That mag is designed not to be dissasembled.

It is a low cap state legal mag.

I have a few so I know.
 
G

·
Discussion Starter #7
That mag is designed not to be dissasembled.

It is a low cap state legal mag.

I have a few so I know.
I dont mind it not being disassembled, I just wish it didnt disassemble itself. Forget it. I'm getting some 30 rounders. :twisted:
 
G

·
Discussion Starter #8
FWIW, I trashed the 10-round mag that came with my Bushy. It never did feed correctly.
So yea, buy some new mags and be done with it.
 
1 - 9 of 9 Posts
Top